Twin Cylinder Points for CCW KEC290 KEC400 KEC440 290 400 440

Ignition Points for CCW KEC290, KEC400, and KEC440 Engines

This ignition points set is an aftermarket replacement contact breaker assembly for CCW KEC290, KEC400, and KEC440 twin cylinder engines, restoring the timed spark these two stroke power plants need to run.

Overview

These points for CCW KEC290, KEC400, and KEC440 engines replace worn or pitted contact breakers in the ignition circuit. Fresh points restore consistent spark timing, which helps a tired twin cylinder engine start and idle properly again. They suit anyone rebuilding or servicing an older CCW powered machine.

Built For Performance

• Contact breaker set designed for twin cylinder CCW KEC engines
• Replacement for worn points that cause weak or erratic spark
• Rated for the 290, 400, and 440 displacement versions
• Simple swap during a tune up or top end rebuild
• Restores factory style ignition timing when gapped and set correctly

Fits These Machines

• for CCW KEC290 twin cylinder engines
• for CCW KEC400 twin cylinder engines
• for CCW KEC440 twin cylinder engines

On-The-Job Use

• Tune ups on vintage snowmobiles and other CCW powered equipment
• Ignition repairs when an engine loses spark or runs rough
• Top end and crankcase rebuilds where the ignition is refreshed at the same time
• Keeping older twin cylinder machines running through the season

Specs At A Glance

Good To Know

Q: Do these points need to be gapped after installation? A: Yes, contact points must be set to the gap the engine maker specifies, and timing checked afterward for proper spark. Follow the service manual for your CCW engine.

Q: Are these original CCW parts? A: No, they are aftermarket replacement points made to fit the listed CCW KEC engines. Confirm your engine code before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.