Universal Black Hydraulic Handbrake Drift Hydro E-Brake Racing Long Level Gear

Universal Hydraulic Handbrake for Drift and Racing

This universal hydraulic handbrake is a hydro e-brake lever built for drift and racing setups, giving the driver direct hydraulic control for rear-wheel lockup during slides and staging.

Overview

This hydraulic handbrake delivers a mechanical lever action that actuates a hydraulic cylinder for consistent rear brake pressure in drift and racing builds. The long lever and e-brake design give the driver extra leverage and control for quick lock-ups. It suits DIY drift projects, track cars, and custom hydro e-brake installations.

Built For Performance

• Long lever arm for increased mechanical leverage and control
• Hydraulic cylinder design for direct, repeatable rear brake actuation
• Black finish that resists corrosion and blends into most interiors
• Universal mounting pattern for custom fabrication and drift builds
• Racing-oriented lever geometry suited to quick, repeated pulls

On-The-Job Use

• Drift competitions and practice sessions
• Track day and rally car builds
• Custom hydro e-brake conversions
• Staging brake setups on race vehicles

Specs At A Glance

Good To Know

Q: Is this handbrake a direct bolt-on for every vehicle? A: It is a universal hydraulic handbrake, so custom mounting and plumbing to a hydraulic cylinder are typically required. Confirm your setup and line routing before ordering.

Q: Does it replace the factory parking brake? A: This unit is built for hydraulic actuation in performance and drift use, not as a standard cable parking brake replacement. Check local rules and your intended use before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.