Universal Excavator Bucket Pin, 100mm Diameter x 750mm Length Chrome 40Cr Steel

Excavator Bucket Pin

A 100mm diameter by 750mm length bucket pin in chrome-finished 40Cr steel, built to secure the bucket-to-arm connection on excavators.

Overview

This universal excavator bucket pin is a 100mm diameter by 750mm length pivot pin made from 40Cr steel with a chrome finish. It locks the bucket to the machine arm and carries the heavy pivot load during digging and swinging. A solid choice for operators replacing a worn or seized pin on a range of excavator setups.

Built For Performance

• 100mm pin diameter matched to common bucket pivot bores
• 750mm overall length for deep boss and arm spacing
• 40Cr steel construction for high tensile strength under load
• Chrome surface finish helps resist corrosion and wear
• Turned cylindrical profile for a clean fit in pivot bores

On-The-Job Use

• Replacing a worn bucket pivot pin during attachment servicing
• Bucket removal and refit between job sites
• General excavator maintenance on the bucket-to-arm joint

Specs At A Glance

Good To Know

Q: Will this pin fit my excavator? A: It is sold as a universal pin at 100mm diameter and 750mm length, so measure your existing pin and bore before ordering. Serial number and model differences can affect fit.

Q: Is this an OEM part? A: No, this is an aftermarket bucket pin, not an original manufacturer component. Match the dimensions to your machine to confirm suitability.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.