Water Manifold Gasket for Polaris Genesis 1200 1999-2004

Water Manifold Gasket for Polaris Genesis 1200

This water manifold gasket seals the cooling passage joints on the Polaris Genesis 1200, replacing the worn or leaking gasket so coolant flows where it should.

Overview

The water manifold gasket is a direct-fit sealing component for the Polaris Genesis 1200 personal watercraft produced between 1999 and 2004. It sits between the manifold and the engine case to stop coolant leaks and keep the cooling circuit pressurized. Anyone servicing a Genesis 1200 cooling system should keep this gasket on hand.

Built For Performance

• Precision-cut to match the factory water manifold bolt pattern
• Seals coolant passages against leaks under normal operating temperatures
• Fits the Genesis 1200 engine platform from 1999 through 2004
• Construction suited to marine wet environments
• Direct replacement for the original sealing part

Fits These Machines

• for Polaris Genesis 1200 (1999)
• for Polaris Genesis 1200 (2000)
• for Polaris Genesis 1200 (2001)
• for Polaris Genesis 1200 (2002)
• for Polaris Genesis 1200 (2003)
• for Polaris Genesis 1200 (2004)

On-The-Job Use

• Cooling system rebuilds on Genesis 1200 watercraft
• Manifold removal and reinstall work
• Fixing coolant seepage at the manifold joint
• Routine top-end maintenance

Specs At A Glance

Good To Know

Q: Do I need to drain the coolant before replacing this gasket? A: Yes, drain the cooling system first so coolant does not spill when the manifold is separated. That also keeps debris out of the passages.

Q: Can I reuse the old gasket? A: No, gaskets are single-use and compress to seal, so a fresh one is needed each time the manifold comes apart. Reusing a worn gasket risks a new leak.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.