Water Manifold Gasket for Polaris Octane 800 2002-2004

Water Manifold Gasket for Polaris

This water manifold gasket seals the cooling water passage on Polaris personal watercraft, preventing leaks at the manifold joint so coolant flows where it should.

Overview

This water manifold gasket is a direct-fit sealing component for Polaris watercraft cooling systems. The gasket sits between the water manifold and the engine mating surface on Polaris Octane 800 models, holding a tight seal under heat and vibration. It is built for riders and mechanics performing routine cooling system service.

Built For Performance

• Precision-cut to match the water manifold port pattern
• Heat-resistant material suited to constant engine temperature cycling
• Compressible enough to seal minor surface imperfections
• Resists swelling and breakdown from continuous water and coolant contact
• Direct replacement footprint for the original manifold gasket
• Installs with standard hand tools during manifold service

Fits These Machines

• for Polaris Octane 800, 2002
• for Polaris Octane 800, 2003
• for Polaris Octane 800, 2004

On-The-Job Use

• Cooling system repairs after a manifold leak is found
• Water manifold removal and reinstallation
• Top-end engine service on Polaris Octane 800 watercraft
• Routine maintenance before the riding season

Specs At A Glance

Good To Know

Q: Should I replace this gasket every time the water manifold is removed? A: Yes, a fresh gasket is recommended any time the manifold is taken off, since used gaskets often lose their ability to seal. A: Reusing an old gasket risks coolant or water leaks at the joint.

Q: Do I need sealant with this gasket? A: Most water manifold gaskets install dry unless the service manual calls for a specific sealant. A: Follow the manufacturer torque sequence for the manifold bolts to avoid uneven sealing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.