Water Manifold Gasket for Polaris SLTX 1050 1996-1999

Water Manifold Gasket for Polaris

This water manifold gasket seals the joint between the manifold and engine on Polaris personal watercraft, preventing coolant leaks under heat and pressure.

Overview

This water manifold gasket is a direct-fit sealing component for Polaris SLTX 1050 watercraft produced from 1996 to 1999. The gasket creates a tight seal at the water manifold mating surface, keeping coolant flowing where it belongs instead of leaking onto hot engine parts. It is built for riders and mechanics performing routine maintenance or top-end rebuilds on these machines.

Built For Performance

• Precision-cut shape matches the water manifold mating surface
• Heat-resistant material holds up under engine operating temperatures
• Compressible construction seals uneven or slightly worn surfaces
• Resists coolant breakdown and swelling over time
• Direct replacement for the factory gasket position

Fits These Machines

• for Polaris SLTX 1050 (1996-1999)

On-The-Job Use

• Water manifold service and reinstallation
• Top-end rebuilds on Polaris 1050 engines
• Coolant leak repair at the manifold joint
• Routine gasket replacement during winterization

Specs At A Glance

Good To Know

Q: Should I replace this gasket every time the manifold is removed? A: Yes, gaskets compress and bond to the surface during use, so a fresh one is recommended each time the manifold is taken off.

Q: Does this gasket require sealant? A: Most installations work fine dry, but a thin layer of gasket sealant can help if the mating surfaces show minor imperfections.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.