Water Manifold Gasket for Polaris SLX 1200 2000-2001

Water Manifold Gasket for Polaris

This water manifold gasket for Polaris seals the cooling water passage between the manifold and engine, preventing leaks on SLX 1200 models from 2000 to 2001.

Overview

This water manifold gasket for Polaris is a direct-fit sealing component for the cooling system on SLX 1200 watercraft from 2000 to 2001. The gasket for Polaris creates a tight seal at the water manifold mating surface, keeping coolant flowing where it should and stopping leaks before they start. It suits riders performing routine maintenance or replacing a worn, weeping gasket during a rebuild.

Built For Performance

• Precision-cut to match the water manifold mating surface for a clean seal
• Constructed from gasket material rated for constant coolant and water exposure
• Resists compression set to maintain sealing force over time
• Direct replacement for the original gasket on SLX 1200 cooling systems
• Simple bolt-on installation with no modification required

Fits These Machines

• for Polaris SLX 1200, 2000
• for Polaris SLX 1200, 2001

On-The-Job Use

• Replacing a leaking water manifold gasket during cooling system service
• Top-end rebuilds where the manifold is removed and resealed
• Routine maintenance to prevent coolant leaks on the water
• Restoring proper water flow through the engine cooling circuit

Specs At A Glance

Good To Know

Q: Does this gasket require sealant during installation? A: Most water manifold gaskets install dry, but a thin gasket dressing can help hold it in place. Follow your service manual for the recommended method.

Q: How do I know if my water manifold gasket needs replacing? A: Look for coolant or water weeping at the manifold joint, low coolant levels, or a visible tear on the gasket surface. Replace it any time the manifold is removed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.