Water Manifold Gasket for Polaris Virage TXI 1200 2001-2002

Water Manifold Gasket for Polaris

This water manifold gasket seals the joint on the cooling system of a Polaris Virage TXI 1200 personal watercraft, keeping coolant flowing where it should and preventing leaks at the manifold surface.

Overview

This water manifold gasket is a direct-fit sealing component for the Polaris Virage TXI 1200 watercraft. It seats between the water manifold and the engine to hold a tight seal under heat and pressure. Riders and mechanics replacing a worn or blown gasket will find this part restores proper cooling flow to the Polaris Virage TXI 1200 engine.

Built For Performance

• Cut to match the factory water manifold bolt pattern for the Polaris Virage TXI 1200
• Seals coolant passages against leaks under operating temperature and pressure
• Compressible material conforms to minor surface irregularities for a tight fit
• Resists breakdown from hot coolant and repeated heat cycles
• Direct replacement for the original gasket on the 2001-2002 Polaris Virage TXI 1200

Fits These Machines

• for Polaris Virage TXI 1200, 2001-2002

On-The-Job Use

• Manifold reseals after coolant leaks are found during service
• Top-end and cooling system repairs on the Polaris Virage TXI 1200
• Routine maintenance when the water manifold is removed and reinstalled

Specs At A Glance

Good To Know

Q: Does this gasket come with mounting hardware? A: No, this listing is for the water manifold gasket only; reuse or replace bolts separately as needed.

Q: Should I clean the mating surfaces before installing? A: Yes, remove all old gasket material and debris from both surfaces so the new gasket seats flat and seals correctly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.