Water Pump & Impeller Kit For Johnson Evinrude 382468 BRP/OMC 777806 18-3377

Water Pump & Impeller Kit for Johnson Evinrude

This water pump and impeller kit, cross-referenced to OEM numbers 382468, 777806, and 18-3107, provides a complete cooling system overhaul for Johnson and Evinrude outboard motors, helping prevent overheating and costly engine damage.

Overview

The Water Pump & Impeller Kit is a comprehensive replacement solution for Johnson and Evinrude outboards, containing all necessary components to rebuild the cooling water pump. It includes the impeller, gaskets, seals, and housing parts, ensuring proper water flow and engine temperature regulation.

Built For Performance

• Includes impeller, gasket set, and wear plate for a complete rebuild
• Neoprene impeller blades resist heat and wear
• Stainless steel or brass insert for corrosion resistance
• Direct fit for OMC/BRP engines using OEM #382468, 777806, 18-3107
• Each kit contains all needed seals and O-rings

On-The-Job Use

• Saltwater and freshwater outboard motors
• Fishing boats, pontoon boats, and runabouts
• Johnson and Evinrude engines from 15hp to 140hp (typical range)
• Annual maintenance or impeller replacement after storage

Specs At A Glance

Good To Know

Q: How often should I replace the impeller? A: It is recommended to replace the water pump impeller every 2-3 years or after 200 hours of operation, whichever comes first, to avoid overheating.

Q: Will this kit fit my specific model? A: This kit is designed for a wide range of Johnson and Evinrude outboards using OEM numbers 382468, 777806, and 18-3107; check your engine serial number to confirm compatibility.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.