Water Pump Rebuild Kit for Arctic Cat 650 4x4 V2 2004-2006

Water Pump Rebuild Kit for Arctic Cat

This water pump rebuild kit restores cooling performance on Arctic Cat 650 4x4 V2 machines, replacing worn seals, bearings, and impeller components so coolant keeps circulating properly.

Overview

This water pump rebuild kit is built for the Arctic Cat 650 4x4 V2 and covers the wear parts that fail most often on a high-hour cooling system. Each water pump rebuild kit for Arctic Cat gives you the seals, bearings, gaskets, and related hardware needed to stop leaks and restore flow.

Built For Performance

• Complete rebuild components for the water pump assembly
• Seals and gaskets designed to resist coolant and heat cycling
• Bearings sized to match the OEM pump housing
• Impeller and shaft wear parts included where applicable
• Direct-fit replacement for the factory pump layout

Fits These Machines

• for Arctic Cat 650 4x4 V2, 2004
• for Arctic Cat 650 4x4 V2, 2005
• for Arctic Cat 650 4x4 V2, 2006

On-The-Job Use

• Routine cooling system service on high-hour machines
• Fixing coolant seepage at the pump weep hole
• Trailside or shop rebuilds after overheating issues
• Preventive maintenance before long riding seasons

Specs At A Glance

Good To Know

Q: Do I need to drain the cooling system first? A: Yes, drain the coolant before removing the pump housing, and refill with the correct mix once the rebuild is complete.

Q: Can I reuse the old gaskets? A: No, always install the new gaskets and seals from the kit to avoid leaks and repeat labor.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.