Water Pump Rebuild Kit for Polaris Indy 600 2013-2020

Water Pump Rebuild Kit for Polaris Indy 600

This water pump rebuild kit renews the coolant pump on the Polaris Indy 600, replacing tired seals, bearings and gaskets so the pump keeps coolant moving through the engine.

Overview

This water pump rebuild kit supplies the wear parts needed to bring the Polaris Indy 600 pump back to spec. It covers the seal, bearing and gasket pieces that fail with age and heat. The kit is aimed at riders and shops servicing 2013 through 2020 Indy 600 sleds that use the matching pump.

Built For Performance

• Seal, bearing and gasket set covering the pump wear points
• Replacement parts matched to the original pump dimensions
• Seals built for the heat and pressure of a snowmobile cooling system
• Bearings sized to the factory pump shaft for straightforward installation
• Gaskets shaped to the stock pump housing

Fits These Machines

• for Polaris Indy 600 2013
• for Polaris Indy 600 2014
• for Polaris Indy 600 2015
• for Polaris Indy 600 2016
• for Polaris Indy 600 2017
• for Polaris Indy 600 2018
• for Polaris Indy 600 2019
• for Polaris Indy 600 2020

On-The-Job Use

• Stopping coolant seepage at the pump weep hole
• Rebuilding the pump alongside a top-end refresh
• Replacing rough or noisy pump bearings
• Off-season maintenance before the riding season starts

Specs At A Glance

Good To Know

Q: Will this kit fit every Indy 600 from 2013 to 2020? A: The kit is listed for the 2013 to 2020 Polaris Indy 600 range, but pump design can vary by build. Check your pump or serial number before ordering.

Q: Is coolant replacement required after the rebuild? A: Yes, the cooling system must be drained first and refilled with the correct coolant, then bled of air. Air left in the system can cause hot spots and overheating.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.