Water Pump Rebuild Kit for Polaris Indy 600 Adventure 2020

Water Pump Rebuild Kit for Polaris Indy 600 Adventure

This water pump rebuild kit restores cooling flow on the Polaris Indy 600 Adventure snowmobile, replacing the worn seals, bearings and gaskets that let coolant weep or the shaft wobble.

Overview

This water pump rebuild kit gives the Polaris Indy 600 Adventure a fresh seal, bearing and gasket set so the pump can move coolant through the engine again. Riders servicing their own sled get every wear item needed to refresh the pump in one package. The kit suits the 2020 Polaris Indy 600 Adventure and other machines sharing the same pump design.

Built For Performance

• Complete seal, bearing and gasket set for a full pump refresh
• Direct replacement for the factory water pump wear parts
• Seals rated for the heat and pressure of a snowmobile cooling system
• Bearings sized to the original pump shaft for a drop-in fit
• Gaskets cut to the original pump housing shape

Fits These Machines

• for Polaris Indy 600 Adventure 2020

On-The-Job Use

• Fixing coolant leaks at the pump weep hole
• Refreshing the pump during a top-end or engine rebuild
• Replacing noisy or rough pump bearings
• Pre-season maintenance before the snow arrives

Specs At A Glance

Good To Know

Q: What is included in the kit? A: The kit contains the seals, bearings and gaskets needed to rebuild the water pump on the listed Polaris Indy 600 Adventure. Confirm the contents against your pump before ordering.

Q: Do I need to drain the cooling system? A: Yes, the coolant must be drained before the pump is opened, then refilled and bled once the rebuild is complete. Trapped air can cause overheating if the system is not bled fully.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.