Water Pump Rebuild Kit for Polaris Pro RMK 800 2011-2016

Water Pump Rebuild Kit for Polaris Pro RMK 800

This water pump rebuild kit services the cooling system on Polaris Pro RMK 800 snowmobiles, supplying the seals, bearings, and gaskets required to seal the pump and keep coolant moving.

Overview

This water pump rebuild kit fits Polaris Pro RMK 800 models from 2011 through 2016 and renews the internals of a worn pump. Riders servicing a Pro RMK 800 use this kit to eliminate coolant leaks and restore reliable circulation before overheating ends a ride. Each piece is matched to the Polaris Pro RMK 800 water pump assembly for a clean rebuild.

Built For Performance

• Seal set built to stop coolant seepage at the pump shaft
• Bearings sized for the Pro RMK 800 pump housing
• Gaskets and O-rings for sealing the pump body and cover
• Materials suited to glycol coolant and cold-weather operation
• Direct-fit rebuild components for the factory pump

Fits These Machines

• for Polaris Pro RMK 800 2011
• for Polaris Pro RMK 800 2012
• for Polaris Pro RMK 800 2013
• for Polaris Pro RMK 800 2014
• for Polaris Pro RMK 800 2015
• for Polaris Pro RMK 800 2016

On-The-Job Use

• Routine cooling system service during preseason maintenance
• Fixing coolant loss traced to a failing pump shaft seal
• Engine rebuilds where the water pump is refreshed at the same time
• Keeping a high-mileage Pro RMK 800 trail ready

Specs At A Glance

Good To Know

Q: Does this kit include everything needed for a full pump rebuild? A: It covers the wear items such as seals, bearings, and gaskets, but the pump housing itself is not included and should be inspected for damage during service.

Q: What coolant should I use after the rebuild? A: Refill with the coolant type specified in your Pro RMK 800 service manual, then bleed the system thoroughly to prevent air pockets.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.