Water Pump Rebuild Kit for Polaris RMK 700 2008-2010 Snowmobile

Water Pump Rebuild Kit for Polaris RMK 700

This water pump rebuild kit restores the cooling system on Polaris RMK 700 snowmobiles, delivering the seals, bearings, and gaskets needed to stop leaks and renew coolant flow.

Overview

This water pump rebuild kit fits Polaris RMK 700 models from 2008 through 2010 and brings tired cooling systems back to full function. Riders rebuilding a high-mileage RMK 700 rely on this kit to replace worn seals and bearings before coolant loss causes overheating on the trail. Every component is selected to match the demands of the Polaris RMK 700 water pump assembly.

Built For Performance

• Complete seal set engineered to stop coolant weeping at the pump shaft
• Bearings sized for the RMK 700 water pump housing
• Gaskets and O-rings to seal the pump cover and body
• Components resistant to glycol coolant and temperature swings
• Direct-fit rebuild pieces for the factory pump assembly

Fits These Machines

• for Polaris RMK 700 2008
• for Polaris RMK 700 2009
• for Polaris RMK 700 2010

On-The-Job Use

• Cooling system refresh during seasonal maintenance
• Repairing coolant leaks traced to a worn pump shaft seal
• Top-end rebuilds where the water pump is serviced alongside the engine
• Restoring an older RMK 700 for continued deep snow riding

Specs At A Glance

Good To Know

Q: Do I need to drain the cooling system before installing this kit? A: Yes, drain the coolant and remove the pump assembly before fitting the new seals and bearings, then refill and bleed the system after reassembly.

Q: Can this kit be installed without removing the engine? A: On most RMK 700 models the water pump can be serviced with the engine in the chassis, but access varies by year, so check your service manual first.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.