Water Pump Rebuild Kit for Polaris Rush 800 2011-2013

Water Pump Rebuild Kit for Polaris Rush 800

This water pump rebuild kit restores cooling performance on the Polaris Rush 800, supplying the seals, bearings, and gaskets needed to refresh a worn pump assembly.

Overview

This water pump rebuild kit for Polaris Rush 800 models provides the components required to reseal and re-bearing a tired coolant pump. It keeps coolant moving through the engine so temperatures stay in the safe range on the trail. Built for riders and mechanics servicing 2011 through 2013 Rush 800 snowmobiles.

Built For Performance

• Complete seal and gasket set for a leak-free pump rebuild
• Bearings sized to the OEM pump shaft for smooth rotation
• Coolant-resistant materials that hold up to glycol exposure
• Mechanical seal designed to stop weepage at the shaft
• Direct replacement fit for the stock pump housing
• Rebuild kit format saves cost versus a full pump assembly

Fits These Machines

• for Polaris Rush 800 2011
• for Polaris Rush 800 2012
• for Polaris Rush 800 2013

On-The-Job Use

• Trailside or shop repair of a weeping water pump
• Scheduled cooling system refresh during top-end service
• Restoring coolant flow after an overheat event
• Pre-season maintenance before the snow flies

Specs At A Glance

Good To Know

Q: Do I need to split the case to install this kit? A: No, the water pump rebuild kit is designed to service the pump assembly without splitting the crankcase on these models.

Q: Should I replace the coolant at the same time? A: Yes, fresh coolant is recommended whenever the pump is opened, and it helps protect the new seals from contamination.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.