Water Pump Rebuild Kit for Polaris Switchback 600 Pro-R 2012-2014

Water Pump Rebuild Kit for Polaris Switchback 600 Pro-R

This water pump rebuild kit services the coolant pump on Polaris Switchback 600 Pro-R snowmobiles, replacing worn seals, bearings, and gaskets to keep coolant moving through the engine.

Overview

The Water Pump Rebuild Kit for Polaris Switchback 600 Pro-R delivers the seals, bearings, and gaskets needed to bring a tired pump back to spec. This water pump rebuild kit suits 2012-2014 Polaris Switchback 600 Pro-R models and is aimed at riders and shops handling their own maintenance. Swap in the kit to end coolant seepage and restore steady flow before the next ride.

Built For Performance

• Fresh seals and gaskets to stop coolant seep at the pump
• Replacement bearings matched to the stock pump shaft
• Bolt-on fit for the years listed with no housing mods
• Restores coolant circulation to keep engine temps in range
• Ideal for routine service and mid-season fixes

Fits These Machines

• for Polaris Switchback 600 Pro-R, 2012
• for Polaris Switchback 600 Pro-R, 2013
• for Polaris Switchback 600 Pro-R, 2014

On-The-Job Use

• Trailside coolant leak repairs on Switchback 600 Pro-R sleds
• Pre-season pump refresh during fall maintenance
• Shop rebuilds after a pump shaft seal failure
• Post-overheat service to restore proper coolant flow

Specs At A Glance

Good To Know

Q: What is included in this kit? A: It includes the seals, bearings, and gaskets required to rebuild the stock water pump on the listed Switchback 600 Pro-R years. Q: Do I need to drain the cooling system first? A: Yes, drain the coolant before removing the pump, then refill and bleed the system afterward to avoid air pockets.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.