Water Pump Rebuild Kit for Polaris Switchback 800 2009-2014

Water Pump Rebuild Kit for Polaris Switchback 800

This water pump rebuild kit restores coolant circulation on Polaris Switchback 800 snowmobiles, bringing a worn pump back to reliable service with fresh seals, bearings, and gaskets.

Overview

The Water Pump Rebuild Kit for Polaris Switchback 800 gives riders a complete seal, bearing, and gasket solution for a pump that has started weeping or dragging. This water pump rebuild kit is built for owners and shops servicing 2009-2010 and 2012-2014 Polaris Switchback 800 machines. Install it to bring coolant flow back in line and keep engine temps stable on the trail.

Built For Performance

• Fresh seals and gaskets to stop coolant weep at the pump housing
• Replacement bearings sized for the stock pump shaft
• Direct fit for the years listed without housing modification
• Restores proper coolant circulation to protect the engine top end
• Suited to routine maintenance and mid-season repair

Fits These Machines

• for Polaris Switchback 800, 2009
• for Polaris Switchback 800, 2010
• for Polaris Switchback 800, 2012
• for Polaris Switchback 800, 2013
• for Polaris Switchback 800, 2014

On-The-Job Use

• Trailside coolant leak repairs on Switchback 800 sleds
• Seasonal pump refresh during pre-winter service
• Shop rebuilds where the pump shaft seal has failed
• Post-overheat service to restore coolant flow

Specs At A Glance

Good To Know

Q: What is included in this kit? A: It ships with the seals, bearings, and gaskets needed to rebuild the stock water pump on the listed Switchback 800 years. Q: Do I need to drain the cooling system first? A: Yes, drain the coolant before removing the pump, then refill and bleed the system after the rebuild to prevent air pockets.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.