Water Pump Repair Kit Seals Bearings for KTM XC-W 250 2006-2016

Water Pump Repair Kit for KTM XC-W 250

This water pump repair kit for KTM renews the cooling system on XC-W 250 models with replacement seals and bearings, fixing leaks and worn pump internals.

Overview

This water pump repair kit for KTM is built for XC-W 250 models from 2006 through 2016. It replaces the seals and bearings that wear out and cause coolant loss or shaft noise in the pump assembly. Enduro riders and home mechanics can use this kit to bring a tired water pump repair kit job back to spec. The components are sized for the pump shaft and impeller assembly on these models.

Built For Performance

• Complete seal and bearing set for the water pump assembly
• Direct replacement for worn or leaking factory components
• Seals rated for continuous coolant contact
• Bearings matched to the pump shaft and impeller
• Restores proper coolant flow through the engine
• Fits KTM XC-W 250 models from 2006 to 2016

Fits These Machines

• for KTM XC-W 250 2006-2016

On-The-Job Use

• Cooling system maintenance on enduro rides
• Trailside repairs when coolant leaks appear
• Off-season rebuilds of the pump assembly
• Fixing a pump with bearing noise or shaft play
• Refreshing a bike before a long event

Specs At A Glance

Good To Know

Q: Can I install this kit without special tools? A: Most pump rebuilds need basic hand tools and a press or drift for the bearings. Check your service manual for the exact procedure on the XC-W 250.

Q: Will this kit stop coolant from weeping at the weep hole? A: Weeping usually points to worn seals, which this kit replaces. If the shaft shows grooves or damage, that part may also need attention.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.