Water Pump Seal Kit for CF-Moto C-Force X6 600 2011-2013 L S

Water Pump Seal Kit for CF-Moto C-Force X6 600

This water pump seal kit is a direct replacement sealing set for the CF-Moto C-Force X6 600, restoring the coolant seal on the water pump so the cooling system holds pressure and the engine stays at operating temperature. It is built as a complete seal solution for riders and mechanics servicing the C-Force X6 600 between 2011 and 2013.

Overview

This water pump seal kit for CF-Moto C-Force X6 600 provides the sealing components needed to rebuild the water pump and stop coolant from leaking past the pump shaft. The kit fits the C-Force X6 600 produced from 2011 through 2013 and is intended for owners and shops performing routine coolant system maintenance or repairing a weeping pump seal. Each seal is sized to match the factory pump housing for a clean, dependable fit.

Built For Performance

• Complete water pump seal kit for the CF-Moto C-Force X6 600 cooling system
• Seals the pump shaft to prevent coolant loss and pressure drop
• Constructed from coolant-resistant sealing material for long service life
• Sized for the factory water pump housing on 2011 to 2013 C-Force X6 600 models
• Direct replacement for worn or leaking pump seals during rebuilds

Fits These Machines

• for CF-Moto C-Force X6 600, 2011
• for CF-Moto C-Force X6 600, 2012
• for CF-Moto C-Force X6 600, 2013

On-The-Job Use

• Servicing a leaking or weeping water pump on the C-Force X6 600
• Cooling system rebuilds during routine engine maintenance
• Stopping coolant loss that causes overheating on the trail
• Shop repair work where a complete pump seal set is required

Specs At A Glance

Good To Know

Q: What does this water pump seal kit do? A: It replaces the seals in the water pump of the CF-Moto C-Force X6 600 to stop coolant leaks and keep the cooling system sealed. A: A fresh seal set helps the pump maintain pressure and protects the engine from overheating.

Q: How do I know if my water pump seal needs replacing? A: Coolant weeping from the pump housing, repeated coolant loss, or overheating are common signs on the C-Force X6 600. A: Replacing the seal kit addresses the source rather than topping off coolant repeatedly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.