Water Pump Seal Kit for CF-Moto U-Force Tracker 800 2013-2014

Water Pump Seal Kit for CF-Moto U-Force Tracker 800

This water pump seal kit is a direct-fit replacement for the CF-Moto U-Force Tracker 800, sealing the pump shaft so coolant circulates properly and the engine holds temperature under load.

Overview

This water pump seal kit for CF-Moto fits the U-Force Tracker 800, providing the seals needed to stop coolant loss at the water pump. It restores a tight seal around the pump shaft on the Tracker 800 so the cooling system keeps pressure and the engine stays within normal range. A practical choice for owners and shops handling 2013 to 2014 models.

Built For Performance

• Complete seal set for the water pump shaft and housing on the Tracker 800
• Formulated to withstand hot coolant and constant shaft rotation
• Addresses weeping seals before they cause coolant loss
• Direct replacement dimensions for a clean rebuild
• Suits 2013 to 2014 U-Force Tracker 800 machines

Fits These Machines

• for CF-Moto U-Force Tracker 800
• for CF-Moto U-Force Tracker 800 2013 to 2014

On-The-Job Use

• Rebuilding the water pump during cooling system maintenance
• Stopping coolant drips at the pump shaft on older machines
• Preventive service before heavy trail or work use
• Shop repairs on U-Force Tracker 800 cooling systems

Specs At A Glance

Good To Know

Q: Does this kit include the pump housing gasket? A: The kit covers the shaft and housing seals as the replacement set, so check your parts diagram if a separate housing gasket is also needed.

Q: Can I keep riding if the pump seal is leaking? A: A leaking seal leads to coolant loss and overheating, so repair it before extended use to avoid engine damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.