Water Temp Sensor for Arctic Cat Bearcat XT Z1 2009-2014
Water Temp Sensor for Arctic Cat Bearcat XT Z1 2009-2014
Couldn't load pickup availability
Water Temperature Sensor for Arctic Cat Bearcat XT Z1
This water temperature sensor for Arctic Cat Bearcat XT Z1 models from 2009 through 2014 monitors coolant temperature and sends that signal to your gauge or ECU for reliable engine management.
Overview
This water temp sensor for Arctic Cat Bearcat XT Z1 machines delivers dependable coolant temperature readings so you can keep an eye on engine heat during long rides. As a direct replacement water temperature sensor for Arctic Cat Bearcat XT Z1 models, it installs in the factory location and connects to the existing wiring. It suits owners performing routine maintenance or replacing a failed sensor.
Built For Performance
- Direct-fit replacement for the factory water temperature sensor location
- Threaded body seals into the coolant passage for a leak-free install
- Electrical connector matches the factory harness plug
- Resists coolant, heat, and vibration under sustained engine operation
- Provides consistent resistance values for accurate gauge readings
Fits These Machines
- for Arctic Cat Bearcat XT Z1, 2009
- for Arctic Cat Bearcat XT Z1, 2010
- for Arctic Cat Bearcat XT Z1, 2011
- for Arctic Cat Bearcat XT Z1, 2012
- for Arctic Cat Bearcat XT Z1, 2013
- for Arctic Cat Bearcat XT Z1, 2014
On-The-Job Use
- Utility and trail riding where consistent coolant monitoring keeps the engine in safe range
- Routine cooling system service and sensor replacement
- Restoring a faulty or inaccurate factory temperature gauge
- Diagnosing overheating issues by confirming sensor signal
Specs At A Glance
| Part Type | Water Temperature Sensor |
| Fitment Years | 2009-2014 |
| Model | Bearcat XT Z1 |
| Machine Type | Snowmobile |
Good To Know
Q: Will this sensor plug into my stock wiring harness? A: Yes, it is built as a direct-fit replacement with a connector designed to match the factory harness on the listed models.
Q: Do I need to drain the coolant to install it? A: Yes, the coolant should be drained below the sensor level before removal to prevent spillage, then refilled and bled after installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
