Water Temp Sensor for Can-Am Commander 800 2011-2015 Temperature
Water Temp Sensor for Can-Am Commander 800 2011-2015 Temperature
Couldn't load pickup availability
Water Temp/Temperature Sensor for Can-Am Commander 800
This water temperature sensor for Can-Am Commander 800 reads coolant temperature and sends the signal your engine management system needs to keep the machine running at the right operating temperature.
Overview
This water temp sensor for Can-Am Commander 800 is a replacement temperature sensor that monitors coolant temperature and relays that reading to your vehicle's ECU or gauge. It is built for riders who need a dependable temperature sensor for Can-Am Commander 800 models and want to restore accurate coolant readings. Whether your original sensor has failed or you are replacing a worn unit, this temperature sensor for Can-Am Commander 800 is a direct-fit solution for 2011 through 2015 machines.
Built For Performance
- Threaded body designed to seat cleanly in the factory coolant port
- Electrical connector matches the OEM plug for straightforward installation
- Resistant to coolant, heat, and vibration found in ATV and side-by-side use
- Provides consistent resistance values across the operating temperature range
- Compact housing fits tight engine bay clearances on Commander 800 models
Fits These Machines
- for Can-Am Commander 800 (2011-2015)
On-The-Job Use
- Restores coolant temperature readings to the dash gauge
- Supports proper ECU fuel and fan control based on engine temperature
- Ideal for routine replacement when the original sensor fails or reads inaccurately
- Commonly used on trail riding, ranch work, and utility duties
Specs At A Glance
| Part Type | Water Temperature Sensor |
| Fitment Years | 2011-2015 |
| Machine | for Can-Am Commander 800 |
Good To Know
Q: Will this sensor work on any Commander 800 from 2011 to 2015? A: It is listed for Commander 800 models built between 2011 and 2015, though final fitment should always be confirmed against your machine's serial number. Q: Do I need to drain the coolant to replace it? A: Some coolant loss is normal when removing the old sensor, so plan to top off or replace coolant after installation and check for leaks.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
