Skip to product information
1 of 2

Water Temp Sensor for Can-Am Outlander 400 2008-2014

Water Temp Sensor for Can-Am Outlander 400 2008-2014

Regular price $46.19
Regular price Sale price $46.19
Sale Sold out
Quantity

Water Temperature Sensor for Can-Am Outlander 400

This water temperature sensor for Can-Am Outlander 400 replaces the OEM temperature sending unit that reports coolant temperature to your engine management system, letting the ECU and dash gauge read real-time operating conditions.

Overview

This water temperature sensor for Can-Am Outlander 400 is a direct-fit replacement for the factory coolant temperature sending unit. It relays coolant temperature data to the engine control module and instrument cluster so the machine runs at the correct air-fuel ratio and warns you before overheating. It suits riders performing routine maintenance or repairing a faulty factory sensor on 2008-2014 Outlander 400 models.

Built For Performance

  • Threaded brass housing for reliable sealing at the coolant passage
  • Thermistor element calibrated for accurate temperature-to-signal output
  • Two-wire connector matching the factory harness plug on Outlander 400 models
  • Sealed electrical connection resistant to coolant, mud, and spray
  • Compact body sized to clear surrounding engine components during install
  • Constructed for consistent readings across repeated heat cycles

Fits These Machines

  • for Can-Am Outlander 400 (2008-2014)

On-The-Job Use

  • Restoring a faulty coolant temperature reading on trail and utility rides
  • Routine cooling system service on Outlander 400 machines
  • Replacing a sensor damaged by coolant leaks or debris
  • Keeping dash temperature warnings accurate during long rides

Specs At A Glance

Part Type Water Temperature Sensor
Fitment for Can-Am Outlander 400, 2008-2014
Connection Two-wire factory-style plug
Function Coolant temperature signal to ECU and gauge

Good To Know

Q: Will this sensor work on my 2008-2014 Outlander 400? A: It is designed for Can-Am Outlander 400 machines built between 2008 and 2014, so verify your model year and engine before ordering. Fit can also depend on serial number.

Q: Do I need to drain the coolant to install it? A: Because the sensor threads into the coolant passage, you will typically lose some coolant during removal, so drain or clamp off the system first. Refill and bleed the cooling system after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details