Water Temp Sensor for Can-Am Outlander 500 2007-2014
Water Temp Sensor for Can-Am Outlander 500 2007-2014
Couldn't load pickup availability
Water Temp/Temperature Sensor for Can-Am Outlander 500
This water temperature sensor for Can-Am Outlander 500 reads coolant temperature and sends that signal to the engine management system so the ECU can manage fuel delivery and cooling fan operation.
Overview
This water temp sensor for Can-Am Outlander 500 is a direct-fit replacement for the original coolant temperature sender on 2007-2014 models. The temperature sensor for Can-Am Outlander 500 threads into the cooling system and reports live coolant temperature to the ECU, which controls fan activation and protects the engine from overheating. It is built for riders doing their own maintenance and shops servicing these machines.
Built For Performance
- Threaded body matches the factory coolant port for direct installation
- Sealed connector resists coolant, heat, and vibration
- Thermistor element delivers accurate resistance across the temperature range
- Weather-resistant housing suited to wet trail and mud conditions
- Plug-and-play wiring connection with no splicing required
- Built to withstand continuous engine bay heat cycles
Fits These Machines
- for Can-Am Outlander 500 (2007-2014)
On-The-Job Use
- Replacing a failed or inaccurate coolant temperature sender
- Restoring correct fan activation on overheating machines
- Routine cooling system service and diagnostics
- Trailside repair when the temperature gauge reads wrong or not at all
Specs At A Glance
| Part Type | Water Temperature Sensor |
| Position | Cooling system / engine block |
| Connection | Factory-style plug connector |
| Fitment Years | 2007-2014 |
Good To Know
Q: How do I know if my temperature sensor has failed? A: Common signs include an erratic or dead temperature gauge, the cooling fan running constantly or never turning on, and fault codes tied to coolant temperature. Replacing the sender usually clears these symptoms.
Q: Does this sensor require any programming after installation? A: No programming is typically needed. Once installed and connected, the ECU reads the sensor signal directly and resumes normal fan and fuel control.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
