Water Temp Sensor for Ski-Doo Grand Touring SE 1997-2000
Water Temp Sensor for Ski-Doo Grand Touring SE 1997-2000
Couldn't load pickup availability
Water Temperature Sensor for Ski-Doo Grand Touring SE
This water temperature sensor monitors coolant temperature on Ski-Doo Grand Touring SE snowmobiles from 1997 through 2000, sending accurate readings to your gauge so you can catch overheating before it becomes a problem.
Overview
This water temperature sensor is a direct replacement part for the Ski-Doo Grand Touring SE built between 1997 and 2000. It reads coolant temperature and relays that signal to your dash gauge or warning system, helping you monitor engine health on every ride. A smart spare for any Grand Touring SE owner doing their own maintenance.
Built For Performance
- Threaded body mounts to the factory coolant port location
- Resistance-based signal compatible with the stock temperature gauge
- Sealed housing resists coolant, moisture, and vibration
- Compact design fits tight engine compartments
- Two-wire connection matches the original harness plug
Fits These Machines
- for Ski-Doo Grand Touring SE 1997
- for Ski-Doo Grand Touring SE 1998
- for Ski-Doo Grand Touring SE 1999
- for Ski-Doo Grand Touring SE 2000
On-The-Job Use
- Trail riding where coolant temps climb on long pulls
- Deep snow conditions that strain the cooling system
- Routine cooling system diagnostics and rebuilds
- Seasonal maintenance before the snow flies
Specs At A Glance
| Part Type | Water Temperature Sensor |
| Position | Coolant Circuit |
| Connection | Two-Wire |
| Fitment Years | 1997-2000 |
Good To Know
Q: How do I know if my temperature sensor has failed? A: A gauge that reads cold constantly, spikes erratically, or triggers false overheat warnings usually points to a bad sensor. Swapping it is a quick, low-cost first step before chasing bigger cooling issues.
Q: Does this sensor need thread sealant when installed? A: A small amount of coolant-safe thread sealant helps prevent weeping at the port, but avoid over-tightening since the body is small. Always drain coolant below the sensor level before removal.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
