Water Temp Temperature Sensor for Polaris Ranger 800 Crew 6x6 2010-2014

Water Temperature Sensor for Polaris Ranger 800 Crew/6x6

This water temperature sensor is a replacement coolant temperature sending unit that provides accurate temperature readings for 2010-2014 Polaris Ranger 800 Crew and 6x6 models.

Overview

This water temperature sensor is designed to replace a worn or failed temperature sending unit on Polaris Ranger 800 Crew and 6x6 machines. It delivers the coolant temperature signal the gauge and engine management system rely on. A practical water temperature sensor for owners maintaining 2010-2014 Ranger 800 platforms.

Built For Performance

• Threaded body matches the factory coolant port mounting
• Sealed connector resists water, mud, and vibration
• Temperature-sensitive element produces a stable resistance signal
• Housing tolerates repeated heat cycles in the engine bay
• Direct-fit replacement for the stock sending unit

Fits These Machines

• for Polaris Ranger 800 Crew, 2010-2014
• for Polaris Ranger 800 6x6, 2010-2014

On-The-Job Use

• Restoring accurate coolant temperature readings on the gauge
• Cooling system maintenance and sensor replacement
• Troubleshooting overheating or erratic gauge behavior
• Engine management input on fuel-injected Ranger models

Specs At A Glance

Good To Know

Q: What causes a temperature sensor to fail on a Ranger 800? A: Age, heat cycling, and coolant contamination can break down the internal element over time. A failed sensor often causes a gauge that reads cold, hot, or fluctuates without matching actual engine temperature.

Q: Can I swap this sensor without draining all the coolant? A: You only need to lower the coolant level below the sensor port to avoid a large spill. Top off and bleed the system afterward, then verify no leaks before operating the machine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.