Water Temp Temperature Sensor for Polaris Ranger 900 Crew 2014

Water Temperature Sensor for Polaris Ranger 900 Crew

This water temp sensor for Polaris Ranger 900 Crew reads coolant temperature and sends that signal to the gauge or ECU so the engine can be monitored and protected.

Overview

This water temperature sensor is a direct-fit replacement for the cooling system on a 2014 Polaris Ranger 900 Crew. The sensor monitors coolant temperature and relays the reading to the dash gauge or engine control unit so overheating can be caught early. It is built for owners doing routine maintenance or chasing a faulty temperature reading on their machine.

Built For Performance

• Threaded body sized to seat in the factory coolant port
• Electrical connector matched to the stock harness plug
• Resistance curve calibrated to send an accurate reading to the gauge or ECU
• Sealed housing resists coolant, heat, and vibration
• Direct replacement for the original sensor location

Fits These Machines

• for Polaris Ranger 900 Crew, 2014

On-The-Job Use

• Replacing a failed sensor that reads hot, cold, or not at all
• Routine cooling system service and refresh
• Diagnosing overheating or warning light issues on the trail
• Restoring an accurate dash temperature gauge reading

Specs At A Glance

Good To Know

Q: How do I know my temperature sensor has failed? A: A failed sensor often causes the gauge to stay pinned cold or hot, or triggers an engine warning even when the coolant is normal. Replacing it restores a reliable reading.

Q: Does this sensor need a sealant or washer when installed? A: Check the installation point on your machine, since most coolant sensors use a crush washer or thread sealant to prevent leaks. Confirm the sensor threads and sealing method match your factory port before fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.