Water Temp Temperature Sensor for Polaris RZR 900 2011-2016

Water Temperature Sensor for Polaris RZR 900

This water temp sensor for Polaris RZR 900 reads coolant temperature and feeds that signal to the gauge or ECU so engine heat stays under control.

Overview

This water temperature sensor is a replacement unit for the cooling system on 2011 to 2016 Polaris RZR 900 models. It measures coolant temperature and sends the reading to the dash gauge or engine control unit to help prevent overheating. It suits owners repairing a faulty sensor or refreshing the cooling system during service.

Built For Performance

• Threaded body that seats in the factory coolant port
• Electrical connector matched to the stock harness plug
• Resistance curve calibrated to send an accurate reading to the gauge or ECU
• Sealed housing resists coolant, heat, and vibration
• Direct replacement for the original sensor location

Fits These Machines

• for Polaris RZR 900, 2011
• for Polaris RZR 900, 2012
• for Polaris RZR 900, 2013
• for Polaris RZR 900, 2014
• for Polaris RZR 900, 2015
• for Polaris RZR 900, 2016

On-The-Job Use

• Replacing a failed sensor that reads hot, cold, or not at all
• Routine cooling system service and refresh
• Diagnosing overheating or warning light issues on the trail
• Restoring an accurate dash temperature gauge reading

Specs At A Glance

Good To Know

Q: How do I know my temperature sensor has failed? A: A failed sensor often causes the gauge to stay pinned cold or hot, or triggers an engine warning even when the coolant is normal. Replacing it restores a reliable reading.

Q: Does this sensor need a sealant or washer when installed? A: Check the installation point on your machine, since most coolant sensors use a crush washer or thread sealant to prevent leaks. Confirm the sensor threads and sealing method match your factory port before fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.