Water Temp Temperature Sensor for Ski-Doo MXZ TNT 600 ACE 2011-2012
Water Temp Temperature Sensor for Ski-Doo MXZ TNT 600 ACE 2011-2012
Couldn't load pickup availability
Water Temperature Sensor for Ski-Doo MXZ TNT 600 ACE
This water temperature sensor monitors coolant temperature on Ski-Doo MXZ TNT 600 ACE snowmobiles from 2011 to 2012, sending the signal your gauge or ECU needs to keep the engine in its safe operating range.
Overview
This water temperature sensor is a direct-fit replacement for the coolant temperature sender on Ski-Doo MXZ TNT 600 ACE models. It reads coolant heat and relays that signal to your temperature gauge or engine management system so you can spot overheating before it turns into a breakdown. Ideal for riders doing routine maintenance or replacing a failed sensor that is triggering warning lights or gauge faults. The water temperature sensor installs at the factory location with no modification required.
Built For Performance
- Direct replacement for the original coolant temperature sender on Ski-Doo MXZ TNT 600 ACE models
- Threaded body matches the factory port for a clean, sealed install
- Provides accurate resistance values across the operating temperature range
- Sealed connector resists moisture, snowmelt, and vibration common on snowmobiles
- Durable housing built to handle repeated heat cycles without signal drift
- Simple plug-in connection to the existing wiring harness
Fits These Machines
- for Ski-Doo MXZ TNT 600 ACE 2011
- for Ski-Doo MXZ TNT 600 ACE 2012
On-The-Job Use
- Replacing a failed coolant temperature sender during seasonal maintenance
- Restoring a temperature gauge or warning light that has stopped reading correctly
- Trailside or workshop repairs on 600 ACE-equipped MXZ TNT snowmobiles
- Preventive replacement before a long riding season
Specs At A Glance
| Part Type | Water Temperature Sensor |
| Position | Coolant temperature sender |
| Compatibility | for Ski-Doo MXZ TNT 600 ACE 2011-2012 |
| Installation | Direct fit, plug-in connector |
Good To Know
Q: How do I know my temperature sensor has failed? A: Common signs include a gauge that stays pinned cold or hot, erratic readings, or a check engine warning on your 600 ACE display. Replacing the sensor is usually the first step before chasing wiring faults.
Q: Does this sensor need any calibration after install? A: No calibration is required, since the sensor is designed to match factory resistance values at each temperature point. Simply install, connect the plug, and confirm the gauge reads correctly once the engine warms up.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
