Skip to product information
1 of 1

Water Temperature Sensor for Ski-Doo Summit Everest 800R P-Tek 2008-2011

Water Temperature Sensor for Ski-Doo Summit Everest 800R P-Tek 2008-2011

Regular price $63.79
Regular price Sale price $63.79
Sale Sold out
Quantity

Water Temperature Sensor for Ski-Doo Summit Everest 800R P-Tek

This water temperature sensor monitors coolant temperature on 2008-2011 Ski-Doo Summit Everest 800R P-Tek snowmobiles and sends the reading to your gauge or ECU so you can spot overheating before it costs you a ride.

Overview

This water temp sensor is a direct replacement coolant temperature sender for the 2008-2011 Ski-Doo Summit Everest 800R P-Tek platform. It reads coolant temperature and feeds the signal to your temperature gauge or engine management so you can monitor heat build-up in the cooling system. It is built for riders who maintain their own sleds and want a dependable sensor without dealer markup.

Built For Performance

  • Threaded body matches the factory coolant port on the 800R P-Tek engine
  • Two-wire connection for a clean, secure plug-in to the factory harness
  • Sealed housing resists coolant, moisture, and vibration
  • Calibrated resistance curve for accurate temperature readings
  • Compact body fits tight spaces around the cylinder head and thermostat housing

Fits These Machines

  • for Ski-Doo Summit Everest 800R P-Tek, 2008-2011

On-The-Job Use

  • Trail riding where consistent coolant temperature monitoring matters
  • Deep powder and mountain riding where heat soak builds on long climbs
  • Routine cooling system maintenance and sensor replacement
  • Diagnosing overheating or gauge fault issues

Specs At A Glance

Type Water temperature sensor
Fitment 2008-2011 Ski-Doo Summit Everest 800R P-Tek
Connection Two-wire plug-in
Function Coolant temperature signal to gauge or ECU

Good To Know

Q: Will this fit my 2009 Summit Everest 800R P-Tek? A: Yes, this sensor is listed for the 2008-2011 Summit Everest 800R P-Tek platform, but confirm your serial number and connector type before ordering since mid-year changes can occur.

Q: Do I need to drain the coolant to install it? A: You will usually need to drain or partially drain the cooling system to avoid coolant loss, then refill and bleed the system after the sensor is threaded in.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details