Wheel Hub &Brake Rotor w/Studs for Can-Am Outlander 450 500 570 650 800 850 1000

Wheel Hub & Brake Rotor with Studs for Can-Am

The Wheel Hub & Brake Rotor with Studs for Can-Am Outlander ATVs combines a hub flange, brake rotor, and pre-installed wheel studs into one ready-to-install unit.

Overview

The Wheel Hub & Brake Rotor with Studs for Can-Am Outlander simplifies front or rear brake service on 450, 500, 570, 650, 800, 850, and 1000 displacements. This assembly replaces a worn hub, warped rotor, or damaged studs with a single component that matches OEM dimensions. Riders doing trail maintenance or heavy utility work trust the Wheel Hub & Brake Rotor with Studs for consistent braking performance.

Built For Performance

• Pre-assembled hub with vented brake rotor for efficient heat dissipation
• Pre-installed wheel studs eliminate the need for separate pressing
• Machined hub face ensures true rotor alignment and reduces runout
• Corrosion-resistant coating protects non-braking surfaces from rust
• Direct-fit design matches OEM stud pattern and offset
• Durable cast iron rotor withstands repeated hard stops

Fits These Machines

• for Can-Am Outlander 450
• for Can-Am Outlander 500
• for Can-Am Outlander 570
• for Can-Am Outlander 650
• for Can-Am Outlander 800
• for Can-Am Outlander 850
• for Can-Am Outlander 1000

On-The-Job Use

• Wheel hub and rotor replacement when bearings are being serviced
• Brake system refresh after mud, water, or heavy trailer towing
• Quick trail-side swap with minimal downtime
• Restoring stopping power on high-mileage Outlander ATVs
• Fleet maintenance for rental or commercial utility machines

Specs At A Glance

Good To Know

Q: Are bearings and seals included with this assembly? A: This wheel hub and rotor assembly ships with pre-installed studs only; wheel bearings, seals, and snap rings are not included and must be sourced separately.

Q: Can this assembly be used on both front and rear axles? A: Yes, these hubs are designed to fit multiple positions on the listed Can-Am Outlander models, but always verify your specific year and displacement to confirm axle fitment.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.