Windshield O-Ring 3/4 for Sea-Doo 1996-1997 Models

Windshield O-Ring, 3/4" for Sea-Doo

This 3/4 inch windshield O-ring is a replacement sealing component made for Sea-Doo 1996-1997 models, sized to sit in the windshield trim channel and hold the shield edge tight.

Overview

This windshield O-ring is a replacement sealing component sized at 3/4 inch for Sea-Doo 1996-1997 models. The O-ring secures the windshield edge in its trim channel and helps limit flex, water intrusion, and vibration along the shield. It is intended for riders and shops servicing older Sea-Doo watercraft that need a fresh seal around the windshield.

Built For Performance

• 3/4 inch profile sized for windshield trim channels on Sea-Doo 1996-1997 models
• Rubber construction that resists water, sun exposure, and repeated flexing
• Holds the windshield edge firmly in the trim channel to reduce rattling
• Helps block spray and moisture from working past the shield edge
• Sold as a replacement sealing piece for worn or missing original O-rings

Fits These Machines

• for Sea-Doo 1996 models
• for Sea-Doo 1997 models

On-The-Job Use

• Replacing a cracked, flattened, or missing windshield seal on older Sea-Doo watercraft
• Routine trim and seal maintenance during offseason servicing
• Shop repairs where the windshield is removed and refitted
• Restoring a shield that vibrates or leaks along its edge

Specs At A Glance

Good To Know

Q: How do I know if my windshield O-ring needs replacing? A: Cracks, flattening, hardness, or a shield that rattles and leaks along the edge usually point to a worn O-ring. Compare the old piece against the 3/4 inch size before installing.

Q: Does this O-ring fit every Sea-Doo windshield? A: It is sized for 1996-1997 Sea-Doo models, but trim channels can differ between model trims. Confirm your model and channel size before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.