Wiper Washer Fluid Level Sensor with O Ring for Altima INFINITI Q50 28911-1E400

Wiper Washer Fluid Level Sensor for Nissan and INFINITI

This wiper washer fluid level sensor, referencing part number 28911-1E400, monitors fluid levels to prevent pump damage in Nissan Altima and INFINITI Q50 models.

Overview

The wiper washer fluid level sensor alerts the driver when the reservoir requires filling by providing an accurate signal to the vehicle computer. This wiper washer fluid level sensor is a direct replacement for 28911-1E400 units found in Nissan and INFINITI vehicles. Reliable performance from the wiper washer fluid level sensor ensures the washer pump does not run dry.

Built For Performance

• Hermetically sealed electronics
• Accurate float-based level detection
• Corrosion-resistant terminal pins
• Includes high-quality O-ring seal

Fits These Machines

• for Nissan Altima
• for INFINITI Q50

On-The-Job Use

• Correcting false low-fluid warnings
• Replacing sensors damaged by old fluid
• System diagnostic and repair

Specs At A Glance

Good To Know

Q: Does this sensor need calibration? A: No calibration is required as the sensor functions automatically upon installation.

Q: Does the reservoir need to be emptied to replace this? A: It is recommended to drain or siphon the fluid below the sensor level to prevent spillage during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.