Wrist Pin Bearing for Tiger Shark Monte Carlo 1000 1997

Wrist Pin Bearing for Tiger Shark

This wrist pin bearing is a small engine component that fits between the connecting rod and piston pin on Tiger Shark Monte Carlo 1000 watercraft, allowing smooth rotation under load.

Overview

This wrist pin bearing serves Tiger Shark Monte Carlo 1000 models from 1997, supporting the piston pin inside the connecting rod small end. The wrist pin bearing reduces friction and wear at the piston-to-rod junction so the top end can run smoothly. It is intended for riders and mechanics servicing or rebuilding a Monte Carlo 1000 engine.

Built For Performance

• Fits Tiger Shark Monte Carlo 1000 applications from 1997
• Roller bearing design supports the piston pin under load
• Rides in the connecting rod small end
• Helps reduce friction and wear at the wrist pin joint
• Commonly replaced during top-end rebuilds

Fits These Machines

• for Tiger Shark Monte Carlo 1000 (1997)

On-The-Job Use

• Top-end rebuilds on Monte Carlo 1000 watercraft
• Piston and connecting rod replacement jobs
• Refreshing a high-hour personal watercraft engine
• Engine teardown and inspection service

Specs At A Glance

Good To Know

Q: When should a wrist pin bearing be replaced? A: It is normally replaced during a top-end rebuild or whenever the piston and connecting rod are serviced.

Q: Is this an OEM Tiger Shark part? A: This is an aftermarket wrist pin bearing made for Tiger Shark Monte Carlo 1000 applications and is not an original factory component.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.