Wrist Pin Bearing for Tiger Shark TS-L 1000 1998

Wrist Pin Bearing for Tiger Shark TS-L 1000

This wrist pin bearing is a replacement connecting rod small-end bearing for the Tiger Shark TS-L 1000 personal watercraft, letting the piston pin spin freely inside the rod under load.

Overview

This wrist pin bearing is built to serve as the small-end bearing inside the connecting rod of the Tiger Shark TS-L 1000 engine. It carries the wrist pin so the piston rocks smoothly against the rod at high rpm. A smart pick for riders refreshing top-end parts on a 1998 Tiger Shark TS-L 1000 during a rebuild or routine service.

Built For Performance

• Roller-style small-end bearing sized for the piston pin of the Tiger Shark TS-L 1000
• Hardened steel rolling elements for reliable load handling at high rpm
• Precision-ground inner and outer surfaces for smooth pin rotation
• Direct replacement for the worn or seized bearing pulled during a top-end rebuild
• Compact caged design keeps rollers evenly spaced under load

Fits These Machines

• for Tiger Shark TS-L 1000
• 1998 model year

On-The-Job Use

• Top-end rebuilds on the Tiger Shark TS-L 1000 engine
• Piston and rod service after a seizure or lean-condition failure
• Routine refresh of upper-end components during off-season maintenance

Specs At A Glance

Good To Know

Q: Should the wrist pin bearing be replaced during every top-end rebuild? A: Yes, it is good practice to swap the wrist pin bearing any time the piston or rod is serviced, since a worn bearing can cause noise and rapid wear on the pin and rod.

Q: Does this bearing need special lubrication before assembly? A: Coat the rollers with clean two-stroke or assembly oil during installation so the bearing is protected during the first start-up.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.