Wrist Pin Bearing for Tiger Shark TS-L 900 1999

Wrist Pin Bearing for Tiger Shark

This wrist pin bearing supports the small end of the connecting rod on 900 engines for Tiger Shark TS-L watercraft, letting the piston pin rotate smoothly under load.

Overview

This wrist pin bearing is a small end rod bearing made for Tiger Shark TS-L 900 models from 1999. It sits between the connecting rod and the piston pin to carry the load as the piston cycles, and it is a wear part that should be replaced during any top end rebuild. It suits riders and shops servicing the 900 engine in these watercraft.

Built For Performance

• Needle roller design for smooth piston pin rotation
• Hardened steel construction for load carrying capacity
• Fits the small end of the connecting rod
• Common replacement during piston and ring service
• Made to 900 engine small end dimensions

Fits These Machines

• for Tiger Shark TS-L 900, 1999

On-The-Job Use

• Top end rebuilds and piston replacement
• Crank and rod service on 900 engines
• Refreshing a high hour watercraft engine
• Shop rebuilds before the riding season

Specs At A Glance

Good To Know

Q: When should a wrist pin bearing be replaced? A: It is normally replaced any time the piston is removed, since the bearing is a wear item that is inexpensive to renew during a rebuild.

Q: Can I reuse the old bearing if it looks fine? A: Reusing a wrist pin bearing is not advised, because roller wear is hard to judge by eye and a failed bearing can damage the rod and cylinder.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.