Wrist Pin Bearing for Yamaha XLT 800 2002-2004

Wrist Pin Bearing for Yamaha

This wrist pin bearing is a replacement connecting rod small end bearing that supports the wrist pin inside your engine for smooth piston movement.

Overview

This wrist pin bearing is a replacement component for the small end of the connecting rod, letting the wrist pin rotate freely under the loads of a running engine. It is intended for Yamaha XLT 800 watercraft from the 2002 to 2004 model years. Whether you are rebuilding a top end or refreshing a tired engine, this wrist pin bearing helps restore reliable piston movement.

Built For Performance

• Roller cage design for smooth wrist pin rotation
• Hardened steel rollers that resist wear under load
• Precision ground bore for a true fit in the rod small end
• Sized for the 800 series wrist pin
• Built to handle sustained rpm in marine two-stroke engines

Fits These Machines

• for Yamaha XLT 800 (2002-2004)
• for Yamaha models running the 800 series engine

On-The-Job Use

• Top end rebuilds on a Yamaha XLT 800
• Wrist pin and piston replacement service
• Crank and rod inspection procedures
• Seasonal engine refresh for personal watercraft

Specs At A Glance

Good To Know

Q: How can I confirm this wrist pin bearing fits my Yamaha? A: Verify your machine is an XLT 800 from 2002 to 2004 and check your parts diagram for the correct bearing. That confirms the fit before you order.

Q: Should I replace other top end parts at the same time? A: Wrist pin bearings are commonly replaced with pistons, rings, and wrist pins during a rebuild. Inspecting the rod small end for wear while it is apart is a smart step.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.