Xplorer 250 .030 Piston Kit for Polaris 2000-2002
Xplorer 250 .030 Piston Kit for Polaris 2000-2002
Couldn't load pickup availability
.030 Piston Kit for Polaris Xplorer 250
This .030 oversize piston kit is made for the Polaris Xplorer 250 and restores top end compression on an engine that has been bored .030 over.
Overview
This .030 piston kit is built for the Polaris Xplorer 250 and gives a worn top end a fresh lease on life. The oversize piston pairs with a matching bore so ring seal and compression come back to spec. It suits riders rebuilding a 2000 to 2002 Xplorer 250 who need a piston kit matched to their machine.
Built For Performance
- .030 oversize diameter for use after boring the cylinder
- Piston body machined to accept the included ring set
- Ring set sized for the .030 over bore
- Wrist pin and clips included for a complete top end job
- Cast construction suited to the Xplorer 250 two stroke engine
Fits These Machines
- for Polaris Xplorer 250 (2000-2002)
On-The-Job Use
- Top end rebuild after cylinder scoring or loss of compression
- Trail and utility riding on the Xplorer 250
- Routine maintenance on high hour two stroke engines
- Shop work where the cylinder is honed or bored to match
Specs At A Glance
| Bore Size | .030 oversize |
| Type | Piston kit |
| Machine | for Polaris Xplorer 250 |
| Years | 2000-2002 |
Good To Know
Q: Does this kit require boring the cylinder? A: Yes, a .030 oversize piston needs the cylinder bored and honed to match before assembly. Confirm the finished bore size with a machinist before ordering.
Q: Can I install this without checking ring end gap? A: No, ring end gap should always be measured and set to the engine spec during assembly. Skipping that step risks poor sealing and a damaged top end.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
