Yamaha Big Bear 350 Carburetor Intake Manifold for 1987-1999 Models

Carburetor Intake Manifold for Yamaha Big Bear 350

This carburetor intake manifold for Yamaha joins the carburetor to the cylinder head, keeping a sealed air-fuel path on 1987-1999 Big Bear 350 models.

Overview

This intake manifold for Yamaha Big Bear 350 is the connecting and sealing part between the carburetor and the engine head. It keeps the air-fuel mixture sealed so the engine starts easily and runs consistently. It is built for owners of 1987-1999 Yamaha Big Bear 350 quads replacing a worn or cracked manifold.

Built For Performance

• Manifold body cast to match the factory mounting pattern
• Flat sealing face for a tight carburetor-to-head fit
• Heat-resistant material for continuous engine bay exposure
• Direct-fit replacement for the stock intake manifold for Yamaha Big Bear 350

Fits These Machines

• for Yamaha Big Bear 350 (1987-1999)

On-The-Job Use

• Fixing vacuum leaks that cause lean running
• Carburetor rebuilds and intake service
• Farm, trail, and utility use where steady power matters
• Maintenance on older Big Bear 350 quads

Specs At A Glance

Good To Know

Q: What are the signs of a failing intake manifold? A: Common signs include rough idle, backfiring, and hard starting from unmetered air entering the intake. A cracked or hardened manifold should be replaced.

Q: Do I need new gaskets when installing this manifold? A: Yes, fresh gaskets are recommended to ensure a proper seal at both the head and carburetor sides. Reusing old gaskets can allow leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.