Yamaha Moto 4 350 Carburetor Intake Manifold for 1987-1995 Models

Carburetor Intake Manifold for Yamaha Moto 4 350

This carburetor intake manifold for Yamaha connects the carb to the engine head, sealing the air-fuel path on 1987-1995 Moto 4 350 models.

Overview

This intake manifold for Yamaha Moto 4 350 is the mounting and sealing joint between the carburetor and the cylinder head. It delivers a stable, leak-free air-fuel path so the engine idles cleanly and pulls hard. It suits riders replacing a cracked or brittle manifold on 1987-1995 Yamaha Moto 4 350 machines.

Built For Performance

• Cast manifold body designed to match the factory bolt pattern
• Sealing surface shaped for an airtight carburetor-to-head joint
• Heat-resistant construction suited to constant engine bay temperatures
• Direct-fit replacement for the stock intake manifold for Yamaha Moto 4 350

Fits These Machines

• for Yamaha Moto 4 350 (1987-1995)

On-The-Job Use

• Restoring proper air-fuel sealing after a cracked manifold
• Carburetor rebuilds and top-end service
• Trail and farm use where reliable idling matters
• Routine maintenance on older Moto 4 350 quads

Specs At A Glance

Good To Know

Q: Why does a cracked intake manifold matter? A: A cracked manifold pulls air past the carburetor and leans out the mixture, causing rough idle or hard starting. Replacing it restores the sealed air-fuel path.

Q: Should I check anything else while the manifold is off? A: Inspect the mounting gasket and carburetor boot for hardening or tears. Fresh gaskets help ensure a leak-free seal after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.